Cisco 300-510 Practice Exams
Last updated on Nov 16,2026- Exam Code: 300-510
- Exam Name: Implementing Cisco Service Provider Advanced Routing Solutions (SPRI)
- Certification Provider: Cisco
- Latest update: Nov 16,2026
When deploying a nationwide network of routers, what is the benefit of using BGP confederations?
- A . availability
- B . scalability
- C . security
- D . automatability
B
Explanation:
Reference: https://www.routerfreak.com/bgp-network-design-bgp-confederation/
Refer to the exhibit.

A customer reports that Host-1 is failing to receive streaming traffic from the IPTV source. The engineer has confirmed that hosts on router R2 are receiving traffic normally and that Host-1 is correctly sending subscription messages to join the IPTV stream.
Which action must the engineer take to correct the problem?
- A . Configure IP PIM SSM and IGMP version 2 under interface GigatxtEthernet 1/0/1 on R3
- B . Configure IGMP version 3 under interface GigabitEthernet 1/(V1 on R3
- C . Remove IP PIM SSM and IGMP from interface GigaEthernet 1/0/1 on R3 and configure under global configuration
- D . Remove IP PIM SSM from the global configuration on R3 and configure it under the GigabitEthernet 1/0/1 interface
Which attribute is used to instruct the router that packets must be processed by an ASA that is associated with the segment?
- A . service SID with service instructions
- B . node SID that identifies a specific network device
- C . prefix SID that represents a specific route prefix
- D . adjacency SID with unidirectional adjacency instructions
Refer to the exhibit.

While troubleshooting a networking issue an engineer identified a suboptimal communication issue on route reflector RR2 In the current environment
✑ Router A is a non-route-reflector client for RR1 and RR2
✑ Routers D and E are directly connected iBGP peers.
✑ Router F is not an iBGP peer of routers D and E
Which action resolves the issue?
- A . Disable BGP Client-to-Client reflection on router RR2.
- B . Enable next-hop-self for BGP peering on router C.
- C . Remove the route-reflector configuration on router RR2.
- D . Enable next-hop-self for BGP peering on router D.
A network engineer recently deployed a wireless network for users at a new office to join video conferences wirelessly. The existing network consists of routers that are configured for EIGRP and BGP. which are located at several data centers in different physical locations The engineer configured PIM-SSM within a single domain from a single source However, during the testing phase, the video conference failed to work for any of the users. The IPs are reachable and firewalls in the network are configured correctly to allow the traffic.
Which action resolves the issue?
- A . Configure PIM dense mode to replace P1M-SSM.
- B . Configure PIM dense mode with multidomain multicast
- C . Configure the devices to send join messages toward a multicast SPT
- D . Configure PIM sparse mode to replace PIM-SSM.
While configuring Cisco NSF awareness, a network engineer enters the bgp graceful-restart command after the BGP session is established in a router that runs IOS XE Software. Graceful restart capabilities are not exchanged.
Which two actions should be taken? (Choose two.)
- A . Reload the router
- B . Verity that BGP route dampening is configured
- C . Reduce BGP convergence time
- D . Issue the clear ip bgp * command
- E . Issue the show ip bgp neighbors command.
AD
Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/iproute_bgp/configuration/xe-16/irg-xe-16-book/bgp-nonstop-forwarding-awareness.html
Refer to the exhibit.

A network engineer has divided AS into confederations. Due to repeated ASN, when the 10.0 0.0/8 prefix from R1 arrives to R2, BGP automatically rejects it.
What should the engineer do to fix the problem so that BGP allows that prefix on R2?
- A . Configure the command as-override on R1.
- B . Configure the command allowas-in on R2.
- C . Configure the command allowas-in on all the PE routers.
- D . Configure the command as-override on R2.
B
Explanation:
Reference: https://www.cisco.com/c/en/us/support/docs/ip/border-gateway-protocol-bgp/112236-allowas-in-bgp-config-example.html
Which type of policy does an IPv6 ISATAP tunnel support?
- A . policies that transmit Connectionless Network Service packets
- B . policies to transmit IPv6 traffic within a site
- C . policies to transmit IPv6 traffic over a point-to-point tunnel
- D . policies that require addresses to have a 2002 716 prefix
Refer to the exhibit.

Router R1 is expected to receive routes that originate from AS 65547 only.
However, R1 is receiving routes from AS 65547 and several other ASs that are directly attached to it.
Which change to the AS path permit filter corrects the problem?
- A . Change the regular expression to $.
- B . Change the regular expression to.*.
- C . Change the regular expression to _65547_.
- D . Change the regular expression to A65547$
DRAG DROP
Drag and drop the BGP attributes from the left into the order of route selection preference on the right.

