Cisco 300-425 Practice Exams
Last updated on Nov 16,2026- Exam Code: 300-425
- Exam Name: Designing Cisco Enterprise Wireless Networks (ENWLSD)
- Certification Provider: Cisco
- Latest update: Nov 16,2026
An engineer is conducting a Layer 2 site survey.
Which type of client must the engineer match to the survey?
- A . best client available
- B . phone client
- C . normal client
- D . worst client available
D
Explanation:
https://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-controllers/116057-site-survey-guidelines-wlan-00.html
An engineer must deploy a wireless network in an open-plan environment that has three SSIDs using the 5 GHz band set to 40 MHz. Co-channel interference must be reduced.
Which two actions must be taken? (Choose two.)
- A . Increase the number of SSIDs.
- B . Increase channel bonding in the 2.4 GHz band to 40 MHz.
- C . Disable band steering.
- D . Decrease channel bonding in the 5 GHz band to 20 MHz.
- E . Reduce the power of the AP.
A customer is concerned about mesh backhaul link security.
Which level of encryption does the backhaul link use?
- A . hash
- B . AES
- C . WEP
- D . 3DES
B
Explanation:
![]()
Two cisco 5520 wireless LAN controllers are managing all access points throughout the network. The WLCs are in different locations to provide geographical redundancy a mobility group has been configured on both WLCs and has a UP status on both controllers. The Aps in location A are statically configured to use controller A as the primary and controller B as the secondary. If the WLC in location A goes offline. The Aps successfully join the WLC in location, but they do not fail over to their primary configured controller.
Which configuration task fixes the issue?
- A . Configure the WLC in location A as primary using the CAPWAP AP Controller IP Address command on all the location A Access points.
- B . Use DHCP Option 43 and specify WLC in location A as primary.
- C . Enable AP fallback globally on the WLC
- D . Change the AP Failover Priority to critical.
Clustering Cisco WLCs into a single RF group enables the RRM algorithms to scale beyond the capabilities of a single Cisco WLC.
How many WLC and APs in an RF group can the controller software scale up to in WLC release 8.9 depending on the platform?
- A . up to 20 WLCs and 1000 APs
- B . up to 20 WLCs and 3000 APs
- C . up to 20 WLCs and 4000 APs
- D . up to 20 WLCs and 6000 APs
D
Explanation:
![]()
https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-9/config-guide/b_cg89/radio_resource_management.html
An engineer has successfully configured high availability and SSO using two Cisco 5508 Wireless LAN Controllers. The engineer can access the Active Primary WLC, but the Secondary Standby WLC is not accessible.
Which two methods allow access to the standby unit? (Choose two.)
- A . via the console connection
- B . SSH to the redundancy management interface of the primary WLC
- C . SSH to the service port interface
- D . SSH to the virtual interface of the secondary WLC
- E . SSH to the management interface of the primary WLC
A,C
Explanation:
![]()
An engineer must create a multicampus architecture wireless design to accommodate 4500 access points for wireless data.
Which model controller the requirements to support all access points on one high availability controller setup?
- A . 3504
- B . 5508
- C . 5520
- D . 8540
An engineer must perform a predictive design for a wireless network for location readiness and to mitigate interference.
Which power level does the engineer use?
- A . 10 mw
- B . 18 mw
- C . 20 mw
- D . 50 mw
A customer has determined that aesthetics is a primary concern for their upcoming guest deployment.
Which design consideration can be leveraged to address this concern?
- A . Paint the access point to cover the LED from being noticeable.
- B . Use enclosures to hide the wireless infrastructure in the surrounding environment.
- C . Use AIR-AP-BRACKET-1 to allow for greater mounting locations
- D . Deploy environmentally friendly cabling components to blend into the environment.
D
Explanation:

A high-density wireless network is designed.
Which Cisco WLC configuration setting must be incorporated in the design to encourage clients to use the 5 GHz spectrum?
- A . Band Select
- B . RRM
- C . Cisco Centralized Key Management
- D . load balancing
A
Explanation:
![]()