Cisco 300-410 Practice Exams
Last updated on Nov 16,2026- Exam Code: 300-410
- Exam Name: Implementing Cisco Enterprise Advanced Routing and Services (ENARSI)
- Certification Provider: Cisco
- Latest update: Nov 16,2026
Which two protocols can cause TCP starvation? (Choose two)
- A . TFTP
- B . SNMP
- C . SMTP
- D . HTTPS
- E . FTP
Refer to the exhibit.

An administrator can log in to the device using Telnet but the attempts to log in to the same device using SSH with the same credentials fail.
Which action resolves this issue?
- A . Configure SSH service on the router
- B . Configure transport input all on the VTY lines to allow SSH
- C . Configure to use the Telnet user database for SSH as well
- D . Configure the VTY lines with login local
Refer to the exhibit.

An administrator can log in to the device using Telnet but the attempts to log in to the same device using SSH with the same credentials fail.
Which action resolves this issue?
- A . Configure SSH service on the router
- B . Configure transport input all on the VTY lines to allow SSH
- C . Configure to use the Telnet user database for SSH as well
- D . Configure the VTY lines with login local
A network administrator successfully established a DMVPN tunnel with one hub and two spokes using EIGRP. One of the requirements was to enable spoke-to-spoke tunnels through the hub router using EIGRP.
Which configuration command must the engineer configure to meet the requirement?
- A . no ip eigrp 1 mode multipoint
- B . no ip eigrp 1 split-horizon
- C . no ip eigrp 1 tunnel-redirect
- D . no ip eigrp 1 mode mgre
SIMULATION



router eigrp 10
no distance 255 0.0.0.0 255.255.255.255
exit
route-map INTERNET1 permit 10
set ip next-hop 209.165.200.238
exit
route-map INTERNET2 permit 10
set ip next-hop 209.165.200.230
exit
router eigrp 10
red ospf 10 metric 100000 1 255 10 1500
exit
int et0/0
ip policy route-map INTERNET1
exit
int et0/1
ip policy route-map INTERNET2
wr
R4
config t
router eigrp 10
no distance 255 0.0.0.0 255.255.255.255 66
red ospf 10 metr 100000 1 255 10 1500
exit
router ospf 10
red eigrp 10 metric 10
wr
Refer to the exhibit.

Which command must be configured to make VRF CCNP work?
- A . interface Loopback0vrf forwarding CCNP
- B . interface Loopback0ip address 10.1.1.1 255.255.255.0
- C . interface Loopback0ip address 10.1.1.1 255.255.255.0vrf forwarding CCNP
- D . interface Loopback0ip address 10.1.1.1 255.255.255.0ip vrf forwarding CCNP
B
Explanation:
From the exhibit, we learn that the command “ip address 10.1.1.1 255.255.255.0” has been issued before the command “ip vrf forwarding CCNP”. But the second command removed the IP address configured in the first command so we have to retype the IP address command.
Refer to the exhibit.


Site1 must perform unequal cost load balancing toward the segments behind Site2 and Site3. Some of the routes are getting load balanced but others are not.
Which configuration allows Site1 to load balance toward all the LAN segments of the remote routers?

- A . Option A
- B . Option B
- C . Option C
- D . Option D
Refer to the exhibit.

After a new regional office is set up, not all guests can access the internet via guest WiFi. Clients are getting the correct IP address from guest Wi-Fi VLAN 364.
Which action resolves the issue?
- A . Allow 10.66.46.0/23 in the outbound ACL
- B . Allow DNS traffic through the outbound ACL
- C . Allow DNS traffic through the inbound ACL
- D . Allow 10.66.46.0/23 in the inbound ACL
An engineer is trying to copy an IOS file from one router to another router by using TFTP.
Which two actions are needed to allow the file to copy? (Choose two.)
- A . Copy the file to the destination router with the copy tftp: flash: command
- B . Enable the TFTP server on the source router with the tftp-server flash: <filename> command
- C . TFTP is not supported in recent IOS versions, so an alternative method must be used
- D . Configure a user on the source router with the username tftp password tftp command
- E . Configure the TFTP authentication on the source router with the tftp-server authentication local command
A newly Installeo router starts establishing an LDP session from another MPLS router to which it is not directly connected.
Which LDP message type responds by target router to the Initiating router using UDP protocol?
- A . notification message
- B . session message
- C . extended discovery message
- D . advertisement message