Fortinet FCSS_EFW_AD-7.4 Practice Exams
Last updated on Nov 16,2026- Exam Code: FCSS_EFW_AD-7.4
- Exam Name: FCSS - Enterprise Firewall 7.4 Administrator
- Certification Provider: Fortinet
- Latest update: Nov 16,2026
Which statement about the designated router (DR) and backup designated router (BDR) in an OSPF multi-access network is true?
- A . Only the DR receives link state information from non-DR routers.
- B . Non-DR and non-BDR routers form full adjacencies to DR only.
- C . Non-DR and non-BDR routers send link state updates and acknowledgements to 224.0.0.6.
- D . FortiGate first checks the OSPF ID to elect a DR.
View the exhibit, which contains the output of diagnose sys session list, and then answer the question below.

If the HA ID for the primary unit is zero (0), which statement is correct regarding the output?
- A . This session is for HA heartbeat traffic
- B . This session is synced with the slave unit.
- C . The inspection of this session has been offloaded to the slave unit.
- D . This session cannot be synced with the slave unit.
Refer to the exhibit, which shows a partial troubleshooting command output.

An administrator is extensively using IPsec on FortiGate. Many tunnels show information similar to the output shown in the exhibit.
What can the administrator conclude?
- A . IPsec SAs cannot be offloaded.
- B . The two IPsec SAs, inbound and outbound, are copied to the NPU.
- C . Only the outbound IPsec SA is copied to the NPU.
- D . Only the inbound IPsec SA is copied to the NPU.
B
Explanation:
The diagnose vpn tunnel list name Hub2Spoke1 command output provides key information about the offloading status of an IPsec VPN tunnel to the Network Processing Unit (NPU).
# npu_flag=20:
# This flag indicates that both inbound and outbound IPsec Security Associations (SAs) have been offloaded to the NPU, meaning the VPN traffic is processed in hardware instead of the CPU.
# npu_rgwy=10.10.2.2 and npu_lgwy=10.10.1.1:
# These IPs represent the remote gateway (rgwy) and local gateway (lgwy), confirming that the tunnel is successfully offloaded.
# npu_selid=1:
# This value means the session selector for the NPU offloaded SA is active.
Since both inbound and outbound SAs are offloaded, the administrator can conclude that the FortiGate NPU is handling IPsec encryption and decryption efficiently, reducing CPU load and improving VPN performance.
Refer to the exhibit, which contains the partial output of an OSPF command.

An administrator is checking the OSPF status of a FortiGate device and receives the output shown in the exhibit.
What two conclusions can the administrator draw? (Choose two.)
- A . The FortiGate device is a backup designated router
- B . The FortiGate device is connected to multiple areas
- C . The FortiGate device injects external routing information
- D . The FortiGate device has OSPF ECMP enabled
B C
Explanation:
The output of the get router info ospf status command provides key information about the OSPF (Open Shortest Path First) configuration on the FortiGate device.
The FortiGate device is connected to multiple areas
# The output states: "This router is an ABR"
#ABR (Area Border Router)means the device is connected tomultiple OSPF areasand maintains routing information between them.
# This confirms that the FortiGate isnot just in one area, but at leastone backbone area (Area 0) and another OSPF area.
The FortiGate device injects external routing information
# The output states: "Supports opaque LSA"
#Opaque LSAs(Type 9, 10, and 11) are used inOSPF extensions, including those that support external route injection.
# Typically, ABRs or ASBRs (Autonomous System Boundary Routers) inject external routes, allowing routes fromother routing protocols (such as BGP or static routes) to be advertised into OSPF.
An administrator wants to capture encrypted phase 2 traffic between two FortiGate devices using the built-in sniffer.
If the administrator knows that there is no NAT device located between both FortiGate devices, which command should the administrator run?
- A . diagnose sniffer packet any ‘ah’
- B . diagnose sniffer packet any ‘ip proto 50’
- C . diagnose sniffer packet any ‘udp port 4500’
- D . diagnose sniffer packet any ‘udp port 500’
Which step can be taken to ensure that only FortiAP devices receive IP addresses from a DHCP server on FortiGate?
- A . Change the interface addressing mode to FortiAP devices
- B . Create a reservation list in the DHCP server settings
- C . Configure a VCI string value of FortiAP in the DHCP server settings
- D . Use DHCP option 138 to assign IPs to FortiAP devices
Refer to the exhibit, wh ch shows a command out
t of an IKE real-time debug.

Why did the tunnel not come up?
- A . The pre-shared keys do not match
- B . The remote gateway phase 1 configuration does not match the local gateway phase 1 configuration.
- C . The remote gateway phase 2 configuration does not match the local gateway phase 2 configuration.
- D . The remote gateway is using aggressive mode and the local gateway is configured to use main mode.
A corporate network allows internet Access to FSSO users only. The FSSO user student does not have internet access after successfully logged into the Windows AD network.
The output of the ‘diagnose debug authd fsso list’ command does not show student as an active FSSO user. Other FSSO users can access the Internet without problems.
What should the administrator check? (Choose two.)
- A . The user student must not be listed in the CA’s ignore user list.
- B . The user student must belong to one or more of the monitored user groups.
- C . The student workstation’s IP subnet must be listed in the CA’s trusted list.
- D . At least one of the student’s user groups must be allowed by a FortiGate firewall policy.
View the exhibit, which contains the output of get sys ha status, and then answer the question below.

Which statements are correct regarding the output? (Choose two.)
- A . The slave configuration is not synchronized with the master.
- B . The HA management IP is 169.254.0.2.
- C . Master is selected because it is the only device in the cluster.
- D . port 7 is used the HA heartbeat on all devices in the cluster.
Examine the following partial output from two system debug commands; then answer the question below.

Which of the following statements are true regarding the above outputs? (Choose two.)
- A . The unit is running a 32-bit FortiOS
- B . The unit is in kernel conserve mode
- C . The Cached value is always the Active value plus the Inactive value
- D . Kernel indirectly accesses the low memory (Low Total) through memory paging