DELL EMC D-PCM-DY-23 Practice Exams
Last updated on Nov 16,2026- Exam Code: D-PCM-DY-23
- Exam Name: Dell PowerSwitch Campus Deploy 2023
- Certification Provider: DELL EMC
- Latest update: Nov 16,2026
What is an accurate statement about configuring a LAG on a Dell EMC N-Series switch?
- A . All interfaces in the port-channel can be configured for different speeds
- B . A port-channel is considered up when all members in the link are up
- C . A physical interface can belong to only one port-channel
- D . At least one interface must be a trunk port
What is the base configuration of an interface connected to a VoIP phone?
- A . Voice VLAN authentication through 802.1x is enabled by default and can be disabled at a per interface level
- B . switchport voice vlan X command on an interface allows the switch to transmit and receive traffic on VLAN X
- C . By default, Dell EMC Campus networking switches will trust both COS and DSCP markings on traffic received from a phone
- D . Switch ports should be configured in trunk mode to allow both data and voice traffic to ingress on separate VLANs
Which Layer 3 protocol does MLAG support?
- A . None
- B . Static Routing
- C . OSPFD.
- D . RIPv2
What are two benefits of using remote user accounts for switch management? (Select 2)
- A . Network administrators with individual accounts.
- B . Accounts usable across multiple network switches.
- C . Simplified password change management.
- D . Accounts not dependent on other network resources.
- E . Higher level of administrative privileges for switches.
Which three statements are true about MLAG? (Select 3)
- A . The peer-link performs the synchronization of FDB and other data.
- B . The backup link is used to prevent split-brain scenarios.
- C . No VLANs can be configured in the peer-link for MLAG switches.
- D . The peer-link can let MLAG switches be in stack for additional redundancy.
- E . User traffic may cross the peer-link for redundancy under some failure scenarios.
In a Dell EMC Campus networking environment, what are the valid port states for RSTP?
- A . Forwarding, Listening, and Blocking
- B . Forwarding, Learning, and Listening
- C . Forwarding, Learning, and Discarding
- D . Forwarding, Learning, and Blocking
When configuring a Layer 2 MAC ACL on a Dell EMC N-Series switch, what is the default MAC address mask?
- A . 00:00:00:00:00:00
- B . 00:01:00:01:00
- C . 0a:0b:0c:0d:0e
- D . 0e:0e:0e:0e:0e
Which methods can be used by an IP phone to put priority on voice traffic?
- A . Layer 2 – 802.1p priority
Layer 3 C DSCP - B . Layer 2 – DSCP
Layer 3 – 802.1p priority - C . Layer 2 – Higher MTU size
Layer 3 – PFC - D . Layer 3 – 802.1p priority
Layer 4 – TCP window size
In the VRRP configuration between two switches, switch A is configured with priority 150 and switch B with priority 100.
Which configuration is valid to trigger fail over if the tracked interface on the Primary unit is down?
- A . Switch-B (config-if)# vrrp 10 track vlan 104 decrement 40
- B . Switch-B (config-if)# vrrp 10 track vlan 104 decrement 60
- C . Switch-A (config-if)# vrrp 10 track vlan 105 decrement 60
- D . Switch-A (config-if)# vrrp 10 track vlan 105 decrement 40
In a PoE environment, which IEEE protocol does a device use to request a power class?
- A . ISDP
- B . LACP
- C . LLDP
- D . CDP