Cisco 350-401 Practice Exams
Last updated on Nov 16,2026- Exam Code: 350-401
- Exam Name: Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR)
- Certification Provider: Cisco
- Latest update: Nov 16,2026
Which function is performed by vSmart in the Cisco Catalyst SD-WAN architecture?
- A . facilitation of NAT detection and traversal
- B . redistribution between OMP and other routing protocols
- C . distribution of IPsec keys
- D . execution of localized policies
Which two conditions occur when the primary route processor fails on a switch that is using dual route processors with stateful switchover? (Choose two.)
- A . Data forwarding is stopped until the routing protocols reconverge after the switchover.
- B . The standby route processor initialization is started when the primary router processor fails.
- C . The standby route processor is fully initialed and state information is maintained.
- D . User sessions are immediately recreated on the new active route processor.
- E . Data forwarding can continue along known paths until routing protocol information is restored.
What is a TLOC in a Cisco Catalyst SD-WAN deployment?
- A . component set by the administrator to differentiate similar nodes that offer a common service
- B . value that identifies a specific tunnel within the Cisco Catalyst SD-WAN overlay
- C . identifier that represents a specific service offered by nodes within the Cisco Catalyst SD-WAN overlay
- D . attribute that acts as a next hop for network prefixes
What are two benefits of using Cisco TrustSec? (Choose two.)
- A . unknown file analysis using sandboxing
- B . advanced endpoint protection against malware
- C . end-to-end traffic encryption
- D . simplified management of network access
- E . consistent network segmentation
SIMULATION 7:


solution below in
Explanation.
Explanation:
Solution:
R3
Config#int et0/1
config-if#ip ospf priority 255
wr
R20
clear ip ospf process
yes
R10
int et0/0
ip ospf priority 0
wr
R2
clear ip ospf process
yes
DRAG DROP
Drag and drop the automation characteristics from the left onto the appropriate tools on the right.
Not all options are used.


Which two operations are valid for RESTCONF? (Choose two)
- A . PULL
- B . ADD
- C . HEAD
- D . REMOVE
- E . GET
- F . PUSH
An engineer is implementing a new SSID on a Cisco Catalyst 9800 Series WLC that must be broadcast on 6 GHz radios. Users will be required to use EAP-TLS to authenticate.
Which wireless Layer 2 security method is required?
- A . WPA3 Personal
- B . WPA3 Enterprise
- C . WPA3 Enterprise
- D . WPA2 Personal
An engineer measures the Wi-Fi coverage at a customer site.
The RSSI values are recorded as follows:
• Location A: -72dBm
• Location B: -75 dBm
• Location C: -65 dBm
• Location D: -80 dBm
Which two statements does the engineer use to explain these values to the customer? (Choose two.)
- A . The signal strength at location B is 10 dB better than location C.
- B . The signal strength at location C is too weak to support web surfing
- C . Location D has the strongest RF signal strength.
- D . The RF signal strength at location B is 50% weaker than location A.
- E . The RF signal strength at location C is 10 times stronger than location B
Refer to the exhibit.

A POST /discovery request spawns an asynchronous task. After querying for more information about the task, the Cisco DNA Center platform returns the REST API response.
What is the status of the discovery task?
- A . restarted
- B . failed
- C . stopped
- D . successful