Cisco 350-401 Practice Exams
Last updated on Nov 16,2026- Exam Code: 350-401
- Exam Name: Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR)
- Certification Provider: Cisco
- Latest update: Nov 16,2026
Question #91
Which action is a LISP Map Resolver responsible for?
- A . forwarding user data traffic
- B . accepting map-request messages from ITRs
- C . finding EID-to-RLOC mappings
- D . accepting registration requests from ETRs
Correct Answer: A
Question #92
Which statement describes the Cisco SD-Access plane functionality for fabric-enabled wireless?
- A . Control plane traffic and data plane traffic are sent to the WLC through VXLAN.
- B . The control plane traffic is sent to the WLC through CAPWAP tunnels, and the data plane traffic is sent from the AP to the fabric edge switch through VXLAN.
- C . The control plane traffic is sent to the WLC through VXLAN, and the data plane traffic is sent to the WLC through CAPWAP tunnels.
- D . Control plane traffic and data plane traffic are sent to the WLC through CAPWAP tunnels.
Correct Answer: B
Question #93
Which AP mode allows an engineer to scan configured channels for rogue access points?
- A . sniffer
- B . monitor
- C . bridge
- D . local
Correct Answer: B
Question #94
SIMULATION 26:


Correct Answer: Solution:
R30
show ip access-list
config t
ip access-list extended 120
5 permit eigrp any any
wr
R20
config t
ip access-list extended 100
permit tcp 192.168.25.0 0.0.0.255 any eq 23
class-map match-any TELNET
match access-group 100
policy-map CoPP
class TELNET
police 10000 conform-action transmit exceed-action drop
control-plane
service-policy input CoPP
wr
R30
show ip access-list
config t
ip access-list extended 120
5 permit eigrp any any
wr
R20
config t
ip access-list extended 100
permit tcp 192.168.25.0 0.0.0.255 any eq 23
class-map match-any TELNET
match access-group 100
policy-map CoPP
class TELNET
police 10000 conform-action transmit exceed-action drop
control-plane
service-policy input CoPP
wr
Question #95
Which feature is available to clients using layer 2 roaming in a wireless infrastructure?
- A . Room to a different wireless controller that is on o different subnet and maintain the same IP address
- B . Associate to a new access point on a different wireless controller and change the IP address without connectivity interruption
- C . Associate to a new access point on the same wireless controller and change the IP address without connectivity interruption
- D . Roam to a different wireless controller that snares The same subnet and maintain the same IP address
Correct Answer: D
Question #96
What is one characteristic of an AP that is operating in Mobility Express mode?
- A . It is recommended for large scale deployments.
- B . It requires a centralized WLC.
- C . At least three APs are needed for WLC redundancy.
- D . It requires an AP to act as a WLC.
Correct Answer: D
Question #97
In a Cisco Mobility Express wireless deployment, which AP takes over if the primary AP fails?
- A . AP with highest IP address
- B . AP with the lowest IP address
- C . AP with highest MAC address
- D . AP with highest controller up time
Correct Answer: C
Question #98
SIMULATION 6:


Correct Answer: Solution:
R3
Int e0/1
Ip ospf priority 255
End
Copy run start
R2
Int e0/1
Ip ospf network point-to-point
End
Copy run start
R10
Int e0/0
Ip ospf network point-to-point
End
Copy run start
R3
Int e0/1
Ip ospf priority 255
End
Copy run start
R2
Int e0/1
Ip ospf network point-to-point
End
Copy run start
R10
Int e0/0
Ip ospf network point-to-point
End
Copy run start
Question #99
In a campus network design, what are two benefits of using BFD for failure detection’? (Choose two.)
- A . BFD speeds up routing convergence time
- B . BFD provides path failure detection in less than a second
- C . BFD provides fault tolerance by enabling multiple routers to appear as a single virtual router
- D . BFD is an efficient way to reduce memory and CPU usage
- E . BFD enables network peers to continue forwarding packets in the event of a restart
Correct Answer: A, B
Question #100
Which tag defines the roaming domain and properties of an AP deployment?
- A . RF tag
- B . policy tag
- C . site tag
- D . AP tag
Correct Answer: C