Network Appliance NS0-163 Practice Exams
Last updated on Oct 22,2026- Exam Code: NS0-163
- Exam Name: NetApp Certified Data Administrator, ONTAP
- Certification Provider: Network Appliance
- Latest update: Oct 22,2026
You want to create an automated test environment that performs a single file SnapRestore. Every time you run the procedure, however, SnapRestore prompts you to confirm your decision to revert the file.
How can you automate this step?
- A . Enter the priv set advanced mode on the storage appliance and the prompt will not appear.
- B . Enable the options snaprestore_noprompts enable=on option.
- C . Use the -f option with the snap restore command.
- D . These prompts are for data protection and auditing and cannot be overridden.
Which one of the following commands is used to specify the destination appliance(s) that are allowed to replicate (pull) data from the source appliance?
- A . options snapmirror.allow
- B . snapmirror release
- C . snapmirror initialize
- D . options snapmirror.access
A NearStore system or storage appliance can operate as a secondary and primary system at the same time.
- A . True
- B . False
The Snap Vault secondary system makes a snapshot of its own volume where the qtrees are located.
A True
B. False
Which statement describes the results of the snapmirror resync command?
- A . Resynchronization finds the newest common snapshot shared by the two volumes or qtrees, and removes all newer information on the storage appliance on which the command is run.
- B . Resynchronization made. cause the loss of all data written to the destination after the original base snapshot was
- C . Resynchronization. update the snapshot on the source filer.
- D . Resynchronization. update the snapshot on the destination filer.
Which one of the following commands is used to specify the destination appliance(s) that are allowed to replicate (pul data from the source appliance?
- A . options snapmirror.allow
- B . snapmirror release
- C . snapmirror initialize
- D . options snapmirror.access
Which one of the following commands is used to specify the destination appliance(s) that are allowed to replicate (pul data from the source appliance?
- A . options snapmirror.allow
- B . snapmirror release
- C . snapmirror initialize
- D . options snapmirror.access
XML-files in /etc/stats/preset are used together with the sysstat command to customize the output.
- A . True
- B . False
When you are setting up SnapMirror, which one of the following is not a replication pre-requisite?
- A . SnapMirror must be licensed for each storage appliance.
- B . The source volume must be offline.
- C . If you are replicating a volume, you must create a restricted volume to be used as the SnapMirror destination volume.
- D . The capacity of the SnapMirror destination must be greater than or equal to the capacity of the source.