Huawei H35-580_V2.0 Practice Exams
Last updated on Oct 22,2026- Exam Code: H35-580_V2.0
- Exam Name: HCIA-5G-RNP&RNO V2.0
- Certification Provider: Huawei
- Latest update: Oct 22,2026
In an inter-frequency handover scenario based on frequency priority, which of the following event measurement reports is used to trigger inter-frequency measurements?
- A . A2
- B . A4
- C . A3
- D . A1
Which of the following descriptions of the newly added RNTI function of 5G are correct? (Multiple choice)
- A . cs-RNTI is used to indicate the scheduling of CSI-RS
- B . INT-RNTI is used for resource preemption information
- C . MCS-C-RNTI is used to indicate the MCS table used by PUSCH/PDSCH
- D . I-RNTI is used to wake up the UE in INACTIVE state
In the gNodeB CU/DU separation architecture, which of the following is the interface between the CU and DU?
- A . F1
- B . N2
- C . X2
- D . eCPRI
If traffic-based SCG addition is enabled, then which protocol layer’s traffic measurement is used to trigger the eNodeB?
- A . PDCP
- B . PHY
- C . MAC
- D . RLC
In SA network, call establishment success rate is related to which of the following indicators? (Multiple choice)
- A . Qos flow establishment success rate
- B . RRC connection establishment success rate
- C . NGSIG connection establishment success rate
- D . SgNodeB addition success rate
In NSA networking scenario, after LTE sends the measurement control of NR cell, which of the following reasons will cause the terminal not to report B1 measurement? (Multiple choice)
- A . The SSB frequency configuration on the LTE side and the NR side is inconsistent
- B . AAU channel power is too low
- C . 5G measurement target cell is not issued
- D . Not all adjacent 5G cells are added
The initial power of PUSCH when carrying msg3 is greater than the initial power when carrying other data
- A . True
- B . False
According to the 3GPP protocol, which of the following subcarrier spacings are supported by the C-band NR system? (Multiple choice)
- A . 60Khz
- B . 120Khz
- C . 15Khz
- D . 30Khz
SMF defines relevant QoS parameters for each QoS flow. For example, under the 501 index, GBR will have parameters such as GFBR, MFBR, RQA and Notification Control.
- A . True
- B . False
In each TTI scheduling, the scheduling priority of the control plane information is absolutely higher than the scheduling of the data plane.
- A . True
- B . False