Cisco 300-420 Practice Exams
Last updated on Nov 16,2026- Exam Code: 300-420
- Exam Name: Designing Cisco Enterprise Networks (ENSLD)
- Certification Provider: Cisco
- Latest update: Nov 16,2026
An architect must address sustained congestion on the access and distribution uplink of network. QoS has already been implemented and optimized, but it is no longer effective in ensuring optimal network performance.
Which two solutions should the architect use to improver network performance? (Choose two)
- A . Reconfigure QoS based on the IntServ model
- B . Utilize random early detection to manage queues
- C . Implement higher-speed uplink interfaces
- D . Bundle additional uplinks into logical EtherChannels
- E . Configure selective packet discard to drop noncritical network traffic.
An engineer must connect a new remote site to an existing OSPF network. The new site consists of two low-end routers, one for WAN, and one for LAN. There is no demand for traffic to pass through this area.
Which area type does the engineer choose to provide minimal router resources utilization, while still allowing for full connectivity to the rest of the network?
- A . not so stubby
- B . totally not so stubby
- C . totally stubby area
- D . stubby area
Refer to the exhibit.

An architect must design a solution to connect bank site A with bank site B and support:
✑ network operation center monitoring end-to-end L3VPN and L2VPN traffic
✑ company adding thousands of routes in the next two years
Which two BGP solutions must the design include? (Choose two.)
- A . Establish full mesh IBGP peering with ail routers in different IGP domains.
- B . Redistribute different IGP domain routes in a BGP IPv4 routing instance.
- C . Transport site routes using a BGP VPNv4 address family on the PE routers.
- D . Apply BGP policies on all routers to filter out ABR and PE loopback IP addresses.
- E . Connect multiple IGP’LDP domains using a BGP IPv4 unicast family on the ABR.
Refer to the exhibit.

Which method must an architect use to provide connectivity between the mail servers?
- A . ISATAP
- B . 6to4
- C . IPv4 compaliDie
- D . 6rd
A network administrator is troubleshooting a DMVPN setup between the hub and the spoke.
Which action should the administrator take before troubleshooting the IPsec configuration?
- A . Verify the GRE tunnels.
- B . Verify ISAKMP.
- C . Verify NHRP.
- D . Verify crypto maps.
When a first hop redundancy solution is designed, which protocol ensures that load balancing occurs over multiple routers using a single virtual IP address and multiple virtual MAC addresses?
- A . GLBP
- B . IRDP
- C . VRRP
- D . HSRP
DRAG DROP
Drag and drop the description from the left onto the corresponding WAN connectivity types and categories on the right.

A customer reports that each time a networking component fails, OSPF recalculates the backup path, with causes a short outage.
Which solution must the customer implement to improve this situation?
- A . Aggressive OSPF timers
- B . LFA FRR
- C . Incremental SPF
- D . BFD
Refer to the exhibit.

An engineer is planning an IPv4 to IPv6 migration solution for a customer. The routers in the network can support IPv4 and IPv6, except for the DWDM routers. The DWDM routers provide a Layer 2 link in which the routers peer directly with each other across a DWDM circuit. The circuit also provides connectivity between the mail servers.
Which IPv6 migration technique must the engineer deploy?
- A . dual-stack
- B . 6to4
- C . ISATAP
- D . 6rd
DRAG DROP
Drag and drop the descriptions from the left onto the categories they apply to on the right.

