Cisco 300-415 Practice Exams
Last updated on Nov 16,2026- Exam Code: 300-415
- Exam Name: Implementing Cisco SD-WAN Solutions (ENSDWI)
- Certification Provider: Cisco
- Latest update: Nov 16,2026
Refer to the exhibit.

Customer XYZ cannot provision dual connectivity on both Its routers due to budget constraints but wants to use tenth RI and R2 interface for users behind them for load toward the hub site.
Which configuration achieves this objectives?
A)

B)

C)

D)

- A . Option A
- B . Option B
- C . Option C
- D . Option D
Which command verifies a policy that has been pushed to the vEdge router?
- A . vEdge# show running-config data policy
- B . vEdge# show policy from-vsmart
- C . vSmart# show running-config policy
- D . vSmart# show running-config apply-policy
B
Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/routers/sdwan/configuration/policies/vedge/policies-book.pdf
Which component is used to optimize the multicast distribution tree enabled through the multicast network?
- A . IGMP client
- B . vManage controllers
- C . VPN concentrator
- D . OMP replicator
Which VPNs must be configured outside the workflow to complete the SD-WAN overlay setup when using the Quick Connect workflow?
- A . service and transport VPNs
- B . service VPNs
- C . transport VPNs
- D . management VPNs
D
Explanation:
The Quick Connect workflow in Cisco SD-WAN simplifies the initial setup process by automating many configuration steps. However, certain configurations still need to be performed outside of this automated workflow to ensure a complete and operational SD-WAN overlay.
Which VPNs must be configured outside the workflow to complete the SD-WAN overlay setup when using the Quick Connect workflow?
- A . service and transport VPNs
- B . service VPNs
- C . transport VPNs
- D . management VPNs
D
Explanation:
The Quick Connect workflow in Cisco SD-WAN simplifies the initial setup process by automating many configuration steps. However, certain configurations still need to be performed outside of this automated workflow to ensure a complete and operational SD-WAN overlay.
Which VPNs must be configured outside the workflow to complete the SD-WAN overlay setup when using the Quick Connect workflow?
- A . service and transport VPNs
- B . service VPNs
- C . transport VPNs
- D . management VPNs
D
Explanation:
The Quick Connect workflow in Cisco SD-WAN simplifies the initial setup process by automating many configuration steps. However, certain configurations still need to be performed outside of this automated workflow to ensure a complete and operational SD-WAN overlay.
What happens if the intelligent proxy is unreachable in the Cisco SD-WAN network?
- A . The grey-listed domains are unresolved
- B . The Cisco Umbrella Connector locally resolves the DNS request
- C . The block-listed domains are unresolved
- D . The Cisco Umbrella Connector temporarily redirects HTTPS traffic
Refer to the exhibit.

vManage and vSmart have an issue establishing a connection to vBond.
Which configuration resolves the issue?
- A . Configure the tunnel interface on all three controllers with a color of transport.
- B . Change the timezone on the vSmart to Europe/London.
- C . Configure the (11.1.1.X/24) IP addresses on the elhO interfaces on vManage and vSmart.
- D . Reconfigure the system-ip parameter on vSmart to 11.1.1.2.
Refer to the exhibit.

A user in the branch is connecting to Office 365 for the first time.
Over which path does the branch WAN Edge router traffic follow?
- A . routing table of the branch WAN Edge router
- B . DIA exit of the branch WAN Edge router
- C . forwarded to the gateway site
- D . dropped because the minimum vQoE score has not been met
An engineer must configure two branch WAN Edge devices where an Internet connection is available and the controllers are in the headquarters. The requirement is to have IPsec VPN tunnels established between the same colors.
Which configuration meets the requirement on both WAN Edge devices?




- A . Option A
- B . Option B
- C . Option C
- D . Option D