Cisco 300-410 Practice Exams
Last updated on Nov 16,2026- Exam Code: 300-410
- Exam Name: Implementing Cisco Enterprise Advanced Routing and Services (ENARSI)
- Certification Provider: Cisco
- Latest update: Nov 16,2026
Refer to the exhibit.

Not all connected and static routes of router B are received by router A even though EIGRP neighborship is established between the routers.
Which configuration resolves the issue?
A)

B)
![]()
C)

D)

- A . Option A
- B . Option B
- C . Option C
- D . Option D
Refer to the exhibit.

An engineer configures router A to mark all inside to outside traffic from network 192 168 1 0, except from host 192 168 1 1. with critical IP precedence. The policy did not work as expected.
Which configuration resolves the issue?
A)

B)

C)

D)

- A . Option
- B . Option
- C . Option
- D . Option
Refer to the exhibit.

The SNMP server with IP address 172.16 4 4 cannot access host router A.
Which configuration command on router A resolves the issue?
- A . snmp-server community ccnp
- B . access-list 4 permit 172.16.4.0 0.0.0.3
- C . access-list 4 permit host 172.16.4.4
- D . snmp-server host 172.16.4.4 ccnp
Refer to the exhibit.

An engineer must configure EIGRP between R1 and R2 with no summary route.
Which configuration resolves the issue?
A)

B)

C)

D)

- A . Option A
- B . Option B
- C . Option C
- D . Option D
Refer to the exhibit.

An engineer applied filter on R1 The interface flapped between R1 and R2 and cleaning the BGP session did not restore the BGP session and failed.
Which action must the engineer take to restore the BGP session from R2 to R1?
- A . Apply the IPv6 traffic filter in the outbound direction on the interface
- B . ICMPv6 must be permitted by the IPv6 traffic filter
- C . Enable the BGP session, which went down when the session was cleared.
- D . Swap the source and destination IP addresses in the IPv6 traffic filter
Refer to Exhibit.

A network administrator added one router in the Cisco DNA Center and checked its discovery and health from the Network Health Dashboard. The network administrator observed that the router is still showing up as unmonitored.
What must be configured on the router to mount it in the Cisco DNA Center?
- A . Configure router with NetFlow data
- B . Configure router with the telemetry data
- C . Configure router with routing to reach Cisco DNA Center
- D . Configure router with SNMPv2c or SNMPv3 traps
B
Explanation:
Unmonitored: Unmonitored devices are devices for which Assurance did not receive any telemetry data during the specified time range.
Which Layer 3 VPN attribute installs customer routes in the VRF?
- A . extended-community
- B . MPLS label
- C . RD
- D . RT
Refer to the exhibit.


In Cuco DNA Center, a network engineer identifies that BGP-learned networks are repeatedly withdrawn from peers.
Which configuration must the engineer apply to resolve the Issue?
A)
![]()
B)
![]()
C)

D)

- A . Option A
- B . Option B
- C . Option C
- D . Option D
configuration on the hub router meets this requirement?
- A . interface Tunnel0tunnel mode gre multipoint
- B . interface Tunnel0 tunnel mode dvmrp
- C . interface Tunnel0 tunnel mode ipsec ipv4
- D . interface Tunnel0 tunnel mode ip
Refer to the exhibit.

After recovering from a power failure. Ethernet0/1 stayed down while Ethernet0/0 returned to the up/up state. The default route through ISP1 was not reinstated m the routing table until Ethernet0/1 also came up.
Which action resolves the issue?
- A . Reference the track object 1 in both static default routes
- B . Remove the references to the interface names from both static default routes
- C . Configure the default route through ISP1 with a higher administrative distance than 2.
- D . Add a static route to the 8 8.8 8/32 destination through the next hop 203.0.113.1